![]() ![]() ![]() I called Keyspan before installing their software since I didn't know what version to install. I took the cable back to the store and bought a Keyspan serial/usb cable #USA-19HS. I called the tech support at Iogear 4 times and found their phone support was worthless. I went and bought a serial/usb cable from a company called Iogear, plugged it in, started the computer and got.nothing. I replaced the usb cable thinking the one shipped was bad and still.nothing. I downloaded the newest version of the Mac driver from this site and once again.nothing. I was told to put my plotter setting to Roland pnc1000 and it should work. When I hooked up the plotter to my computer through the supplied USB cable and installed the recommended serial/usb driver I got NOTHING. I'm not new at this so it was especially frustrating. After receiving the plotter I played hell getting my computer to communicate with it. I am running FlexiSign-Pro 6.6 in "classic" mode on a newer Mac. I recently bought a UScutter MH1351 50" cutter. I still run a Roland pnc1100 plotter and have had no issues. Back when it was ONLY available for a Mac in the early 1990's before they entered the windows world. I have been using FlexiSign on a Mac since FlexiSign was introduced. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |